Knowledge

How to select a plate heat exchanger?

Oct 31, 2023 Leave a message

1. Plate type selection

The plate type or corrugated type should be determined according to the actual needs of the heat exchange situation. For situations where the flow rate is high and the pressure drop is small, the plate type with low resistance should be selected. On the contrary, the plate type with high resistance should be selected. Based on the fluid pressure and temperature, the selection of detachable or brazed type should be determined. When determining the plate type, it is not advisable to choose plates with too small single plate area to avoid excessive number of plates, small flow rate between plates, and low heat transfer coefficient, For larger heat exchangers, more attention should be paid to this issue.

2. Pressure drop verification

In the design and selection of plate heat exchangers, there are generally certain requirements for pressure drop, so it should be checked. If the checked pressure drop exceeds the allowable pressure drop, the design and selection calculation need to be redone until the process requirements are met.

3. Selection of processes and flow channels

Process refers to a group of parallel flow channels in a plate heat exchanger where a medium flows in the same direction, while flow channels refer to the medium flow channels composed of two adjacent plates in the plate heat exchanger. Generally, several flow channels are connected in parallel or series to form different combinations of cold and hot medium channels.

4. Thermal power. The thermal power should not be too high or too low, as either too high or too low will affect our use.

Send Inquiry