Knowledge

how do you clean a heat exchanger

Dec 25, 2024 Leave a message

To clean the heat exchanger, you can follow these steps:
Prepare tools and materials:
Compressor and water 1;
Suitable cleaning brush, such as nylon brush 1;
High quality cleaning agents (avoid choosing low-quality cleaning agents) 2.
Disassemble some components of the heat exchanger:
Remove the short connector 1 from the heat exchanger pipeline;
Use a wrench or socket wrench to loosen the fastening bolts on the head of the heat exchanger, rotating the head 180 degrees to expose heat transfer tube 1.
Clean the heat transfer tube:
Insert the nylon brush into the heat transfer tube to ensure that the nylon brush can fully contact the gas block 1;
Insert the air gun into the mouth of the heat transfer tube, hold the air gun horizontally, and ensure that the air gun compresses 1 on the sealing gasket;
Unscrew the valve on the air gun and let the compressed air push the nylon brush forward. When the nylon brush comes out from the other end of the heat transfer tube, close valve 1;
Push the nylon brush back from the other end of the heat exchanger and repeat brushing three times;
Rinse heat transfer tube 1 with a water pressure of 0.3MPa.
Repeat cleaning:
Repeat the above cleaning steps for each heat transfer tube until all heat transfer tubes are cleaned.
Inspection and assembly:
Check the cleanliness of the heat exchanger and whether there are any damaged or worn parts;
After confirming the correctness, reassemble the heat exchanger.
Regular cleaning:
It is recommended to clean the heat exchanger at least once a month, or when the device emits a warning sound and the heat exchanger indicator light is on.
During the cleaning process, it is important to avoid damaging the fins or other sensitive components of the heat exchanger. If you encounter any problems or need further assistance during the cleaning process, please contact professionals or equipment manufacturers for consultation.

Send Inquiry