Knowledge

Five common structures of plate heat exchangers

Oct 21, 2023 Leave a message

There are many application industries for plate heat exchangers, and there may be different structures for different industries. Below, we will briefly understand the five common structures.

1. Unequal channel area plate heat exchanger

This type of plate heat exchange can operate the fluid flow rate under different conditions, so that the flow rate through the plates is similar or equal, and its cross-sectional area ratio can reach at least 2:1.

2. Large gap plate heat exchanger

Fluids containing fibers and coarse particles are prone to blockage in ordinary plate heat exchangers. High viscosity fluids also have significant flow resistance between plates. By increasing the gap between the heat exchange plates, the above problems can be successfully solved. The gap of the product channel can reach 16mm, and the shape of the plate can enable the heat exchanger to achieve high turbulence and heat transfer efficiency.

3. Double wall plate heat exchanger

Double wall plate heat exchangers are suitable for situations where harmful reactions occur when two types of heat exchanger media are mixed with each other. Double plates are used instead of single plates that are usually between the two media. The channel formed by assembling the double plates is sealed with a sealant pad. Perforation on the double board will cause the medium to leak between the boards, thus flowing out from between the boards, so that people can repair and replace it in a timely manner after discovering it, ensuring that the two media cannot mix with each other.

4. Double plate welded (fully welded) plate heat exchanger

Many products in the petrochemical industry are corrosive to rubber materials, and it is generally impossible to use plate heat exchange with rubber gaskets. The welded plate exchanger adopts a fully welded or double plate welded structure, and leakage is generally not easy to occur.

5. Graphite plate heat exchanger

Graphite plate heat exchanger is a product developed due to the strong corrosiveness of certain media to rare metals or gold. The heat transfer plate is molded from raw materials made of graphite and fluoroplastics, and is equipped with thin flat gaskets made of anti-corrosion materials. The graphite plate has good corrosion resistance and heat transfer performance, and has small thermal expansion, without plastic deformation under high temperature and pressure.

Send Inquiry