News

How To Improve The Efficiency Of Plate Heat Exchangers?

Jan 22, 2024 Leave a message

The frequency of use of the heat exchanger is relatively high. Properly increasing the heat transfer coefficient of the heat exchanger can only effectively improve the heat transfer coefficient of the heat exchanger by simultaneously increasing the surface heat transfer coefficient on both sides of the plate, reducing the thermal resistance of the fouling layer, selecting plates with high thermal conductivity, and reducing the thickness of the plates.
1. Due to the ripple effect of plate heat exchangers, the fluid can generate turbulence at lower flow rates, resulting in higher surface heat transfer coefficients. The surface heat transfer coefficient is related to the geometric structure of the plate ripple and the flow state of the medium. The waveform of the plate includes herringbone, straight, spherical, etc. After years of research and experimentation, it has been found that herringbone plates with triangular corrugated cross-sections have higher surface heat transfer coefficients, and the larger the angle between the ripples, the higher the flow velocity of the medium in the inter plate flow channel, and the larger the surface heat transfer coefficient.
The key to reducing the thermal resistance of the fouling layer in heat exchangers is to prevent plate fouling. When the thickness of the plate fouling is 1mm, the heat transfer coefficient decreases by about 10%. Therefore, it is necessary to pay attention to monitoring the water quality on both the hot and cold sides of the heat exchanger to prevent plate fouling and prevent impurities from adhering to the plates in the water. Some heating units add chemicals to the heating medium to prevent water theft and corrosion of steel components. Therefore, it is necessary to pay attention to water quality and adhesives that may cause impurities to contaminate the heat exchanger plates. If there are viscous impurities in the water, a dedicated filter should be used for treatment. When selecting drugs, it is advisable to choose non viscous drugs.
3. The material of the plate can be stainless steel, titanium alloy, copper alloy, etc. Stainless steel has good thermal conductivity, with a thermal conductivity of about 14.4 W/(m • K), high strength, good stamping performance, and is not easily oxidized. Its price is lower than titanium and copper alloys, and it is commonly used in heating engineering, but its ability to resist chloride ion corrosion is poor.

Send Inquiry